MidwayUSA
Show:
Sort by:
Search this category
cancel
Previous 1 ...
  1. 1
  2. 2
  3. 3
  4. 4
... 4 Next

Gunsmithing - Correcting Excess Cylinder Endshake on a S&W Revolver

06-Jan-2012
Note: To rate a video, click a star in the upper left corner of the video.
Views: 12285
Average Rating: 5/5
# of Ratings: 21
This media is still being converted.  This media is pending review .

When the cylinder of a revolver has a lot of front to back play or movement, it’s called end shake. It’s a problem that is easily corrected if you have the right parts. In this GunTec video Larry Potterfield, Founder and CEO of MidwayUSA, demonstrates the process for correcting the cylinder. After measuring for the exact amount of end shake using a feeler gage, he begins by removing the yoke retaining screw, the yoke, and the cylinder. Using a padded vise and some snap caps to protect the extractor, he disassembles the cylinder assembly. A Power Custom cylinder end shake bushing is used to take up the slack in the cylinder to yoke fit. These bushings measure only two thousandths of an inch thick. Once the bushing is lubricated it is dropped into the cylinder and the gun is reassembled and checked for proper fit.

switch page loading... 
MediaSpace™ video portal by Kaltura